Breaking Z3
Breaking Z3
I'm breaking our 2002 Z3 2.2 (Topaz Blue). Most parts available, please ask.
The car was in pristine condition with low mileage when it met a sticky end (frontal damage).
Sold so far:
Interior
Soft top
Roll bars
Mesh wind deflector
Rear light clusters
The remaining bits (including hard top) are in Sussex.
Cheers
Paul
The car was in pristine condition with low mileage when it met a sticky end (frontal damage).
Sold so far:
Interior
Soft top
Roll bars
Mesh wind deflector
Rear light clusters
The remaining bits (including hard top) are in Sussex.
Cheers
Paul
Re: Breaking Z3
I don't suppose the front numberplate holder surived did it? Mine has had a crack in it since I bought the car, and I think it is time to replace it.
1997 Z3 2.8 in Montreal Blue, only 130k on the clock!
OEM Roll Hoops
M50B25 Inlet manifold
BMC CDA Induction kit
Beige roof
OEM Roll Hoops
M50B25 Inlet manifold
BMC CDA Induction kit
Beige roof
-
- Joined: Wed 02 May, 2012 03:50
- Posts: 8
- Contact:
Re: Breaking Z3
Good Morning,
I am missing the right hand small panel next to the spot light if you have it. Cheers
I am missing the right hand small panel next to the spot light if you have it. Cheers
- LookinFoolish
- Joined: Sun 31 Jul, 2011 18:36
- Posts: 294
- Contact:
Re: Breaking Z3
It's a long shot but are the alloys the 'star alloys' i'm after? see my thread for a pic.
1997 BMW Z3 1.9l
Re: Breaking Z3
I know you've sold the roll bars but do you happen to have the two metal supports that the inner ends of the bars go into?
1997 2.8 Z3 | Gallery Thread
Re: Breaking Z3
Sorry. They're quite traditional.LookinFoolish wrote:It's a long shot but are the alloys the 'star alloys' i'm after? see my thread for a pic.
Cheers
Paul
Re: Breaking Z3
Sorry. They went with the roll bars.XVar wrote:I know you've sold the roll bars but do you happen to have the two metal supports that the inner ends of the bars go into?
Cheers
Paul
Re: Breaking Z3
Sorry. it's probably still embedded in the driver's door of a Ford Fiestwildeboy wrote:I don't suppose the front numberplate holder surived did it? Mine has had a crack in it since I bought the car, and I think it is time to replace it.
To answer other queries, the front end damage accounted for the bonnet, radiator, and lights. I think one spotlight might have survived. The steering rack survived. The two flitch panels survived.
Cheers
Paul
- LookinFoolish
- Joined: Sun 31 Jul, 2011 18:36
- Posts: 294
- Contact:
Re: Breaking Z3
Hi. Do you have a complete near side mirror assembly? Cheers
Re: Breaking Z3
No, they were body colour and now sold anywayLookinFoolish wrote:I don't suppose the car had chrome grills/vents on the side?
Paul
Re: Breaking Z3
I have both mirrors but I'm already negotiating on them as a pair. If that doesn't work out, I'll say.jj29 wrote:Hi. Do you have a complete near side mirror assembly? Cheers
Paul
-
- Joined: Tue 24 Apr, 2012 08:10
- Posts: 4
Re: Breaking Z3
i would possibly purchase the drivers side mirror, depending on price.
Re: Breaking Z3
Hi I might be interested in rear bumper and sills / skirts if the are in good condition.
Regards,
Steve
Regards,
Steve
Re: Breaking Z3
Please contact me Steve, and we'll discuss.z3steve wrote:Hi I might be interested in rear bumper and sills / skirts if the are in good condition.
Regards,
Steve
Paul
paul@fldc.co.uk
07813 641644
Re: Breaking Z3
I think the mirrors are sold. If not, I'll let you know.Crustyclown777 wrote:i would possibly purchase the drivers side mirror, depending on price.
Cheers
Paul
Re: Breaking Z3
Hi
Looking for the plastic deflectors that sit in front of the rear wheels on the underbody just at the rear ends of the sills.
Mine have both cracked and the passenger one has fallen apart ...........
Thank You
Looking for the plastic deflectors that sit in front of the rear wheels on the underbody just at the rear ends of the sills.
Mine have both cracked and the passenger one has fallen apart ...........
Thank You
----------------- BMW Z3 Das Beste Auto -----------------
Mein altes Auto riecht nach Nudeln, hat dieses Auto eine Wurst Geruch.
Mein altes Auto riecht nach Nudeln, hat dieses Auto eine Wurst Geruch.
-
- Joined: Wed 02 May, 2012 03:50
- Posts: 8
- Contact:
Re: Breaking Z3
Hi,
Looking for the plastic cover which fits inside the boot of the Z3, protecting the light, mine leaks like mad
Phil Locke
Looking for the plastic cover which fits inside the boot of the Z3, protecting the light, mine leaks like mad
Phil Locke
Re: Breaking Z3
Do you mean the wheel arch liners?Vic-Z3 wrote:Looking for the plastic deflectors that sit in front of the rear wheels
I'll see what's there and contact you.
Cheers
Paul
Re: Breaking Z3
I'll see what's there and contact you.Old Bill Phil wrote:Looking for the plastic cover which fits inside the boot of the Z3, protecting the light
Cheers
paul
Re: Breaking Z3
lotocone wrote:I have the plastic panel that fits between the two light units and accommodates the triangle. The plastic bits on the back of the light units were sold.Old Bill Phil wrote:Looking for the plastic cover which fits inside the boot of the Z3, protecting the light
Cheers
paul
Re: Breaking Z3
Hi,
Might you have the radio aerial for sale and if so how much?
Graham
Might you have the radio aerial for sale and if so how much?
Graham
-
- Joined: Sat 19 May, 2012 21:24
- Posts: 2
Re: Breaking Z3
Hi
I dont suppose you have passengers seat adjustment switch have you?
I dont suppose you have passengers seat adjustment switch have you?
-
- Joined: Wed 02 May, 2012 03:50
- Posts: 8
- Contact:
Re: Breaking Z3
Thanks for that, how about the plastic panel that sits next to the spotlights?
Re: Breaking Z3
Sorry, went last weekSkeggy wrote:Might you have the radio aerial for sale and if so how much?
Re: Breaking Z3
Sorry, it went with the seatsAussieinkent wrote:I dont suppose you have passengers seat adjustment switch have you?
Re: Breaking Z3
I'm afraid the front end was lost in the impact.Old Bill Phil wrote:Thanks for that, how about the plastic panel that sits next to the spotlights?
Cheers
Paul
-
- Joined: Sun 27 May, 2012 12:07
- Posts: 6
Re: Breaking Z3
hi
i am looking for a passenger side door mirror can you help please
thanks barry
i am looking for a passenger side door mirror can you help please
thanks barry
Re: Breaking Z3
did/does the car have headlight washers? and if so did the passenger side one survive?lotocone wrote:Sorry. it's probably still embedded in the driver's door of a Ford Fiestwildeboy wrote:I don't suppose the front numberplate holder surived did it? Mine has had a crack in it since I bought the car, and I think it is time to replace it.
To answer other queries, the front end damage accounted for the bonnet, radiator, and lights. I think one spotlight might have survived. The steering rack survived. The two flitch panels survived.
Cheers
Paul
do you have the Door sills?
-
- Joined: Sun 27 May, 2012 12:07
- Posts: 6
Re: Breaking Z3
hi
i need a complete passenger side door mirror in good condition preferably in montreal blue but any colour will do can you help please.
regards
barry
barryandangela1980@sky.com
i need a complete passenger side door mirror in good condition preferably in montreal blue but any colour will do can you help please.
regards
barry
barryandangela1980@sky.com
Re: Breaking Z3
If you have the steering rack still, send me a pm with price. Would need it posting up north.
Cheers,
Mark
Cheers,
Mark
Z3M with a few mods...and a little bit more power
Re: Breaking Z3
Hi, I am collecting a 1997 Z3 later this week. It's had a lot of mechanical work done in the past, but needs a bit of tlc. Did the steering wheel go when the interior went? I need an M sport wheel in better condition than the current one.
I will be looking for a wine deflector, fitted mats, maybe your hardtop. How much do you want for it? I'm originally from Sussex so a trip back from Dorset would not be a problem.
Thanks
Flossy
I will be looking for a wine deflector, fitted mats, maybe your hardtop. How much do you want for it? I'm originally from Sussex so a trip back from Dorset would not be a problem.
Thanks
Flossy
-
- Joined: Wed 02 May, 2012 03:50
- Posts: 8
- Contact:
Re: Breaking Z3
I don,t suppose you have the gear knob? Its the one with the white insert in i am after
Regards
Regards
Re: Breaking Z3
I think I need one of those as well, I just can't seem to keep the stuff in the glass when I go round a corner!!FLOSSY wrote:I will be looking for a wine deflector,
Welcome to the forum FLOSSY, you are in the right place for advice on TLC for the zed, but be warned, TLC can easily turn into compulsive modification!!!
Don't forget to post up some photos when you get it
1997 Z3 2.8 in Montreal Blue, only 130k on the clock!
OEM Roll Hoops
M50B25 Inlet manifold
BMC CDA Induction kit
Beige roof
OEM Roll Hoops
M50B25 Inlet manifold
BMC CDA Induction kit
Beige roof
Re: Breaking Z3
you better change your name to wineboy and yes TLC is how I started off .now its still going headstrong after a few grand and I want more toyswildeboy wrote:I think I need one of those as well, I just can't seem to keep the stuff in the glass when I go round a corner!!FLOSSY wrote:I will be looking for a wine deflector,
Welcome to the forum FLOSSY, you are in the right place for advice on TLC for the zed, but be warned, TLC can easily turn into compulsive modification!!!
Don't forget to post up some photos when you get it
Re: Breaking Z3
Do you have the rear subframe and prop? I think they should fit my pre-facelift 2.8. Can they be couriered?
Cheers
Marc
Marc
-
- Joined: Sun 27 May, 2012 12:07
- Posts: 6
Re: Breaking Z3
hi
do you have a passenger door mirror complete please.
thanks
barry
hi i am still looking for a passenger door mirror can you help please
regards
barry
01740645084
do you have a passenger door mirror complete please.
thanks
barry
hi i am still looking for a passenger door mirror can you help please
regards
barry
01740645084
Last edited by barryandangela1980 on Thu 07 Jun, 2012 10:20, edited 1 time in total.
- EnthuZiaZT
- Joined: Sat 12 Sep, 2009 14:27
- Posts: 443
- Location: Heacham, Norfolk
- Contact:
Re: Breaking Z3
Have you still got the underbonnet reservoir for the windscreen washers? Ours has broken off from the fixing bracket.
Mike & Sandy - Mora Metallic Individual 2.0L
IMG_1038.jpg~original
IMG_1038.jpg~original
Re: Breaking Z3
Sorry the mirrors now adorn another carbarryandangela1980 wrote:hi
i am looking for a passenger side door mirror can you help please
thanks barry
Cheers
Paul
Re: Breaking Z3
I don't think it had headlight washers. If it did then no luck I'm afraid.Monkey wrote:did/does the car have headlight washers? and if so did the passenger side one survive?
Do you mean the metalwork that runs between the wheel arches? If so yes.Monkey wrote:do you have the Door sills?
If you mean the trim that fits in the bottom of the door reveal then no, sorry.
Cheers
Paul
Last edited by lotocone on Thu 07 Jun, 2012 15:56, edited 1 time in total.
Re: Breaking Z3
PM sentDeano1712 wrote:If you have the steering rack still, send me a pm with price. Would need it posting up north.
Cheers,
Mark
Re: Breaking Z3
PM sentFLOSSY wrote:Hi, I am collecting a 1997 Z3 later this week. It's had a lot of mechanical work done in the past, but needs a bit of tlc. Did the steering wheel go when the interior went? I need an M sport wheel in better condition than the current one.
I will be looking for a wine deflector, fitted mats, maybe your hardtop. How much do you want for it? I'm originally from Sussex so a trip back from Dorset would not be a problem.
Thanks
Flossy
Re: Breaking Z3
I do.msassoon wrote:Do you have the rear subframe and prop?
I don't see why not, but I'll ask a pal who knows about these things.msassoon wrote: I think they should fit my pre-facelift 2.8.
Anything's possible!msassoon wrote: Can they be couriered?
PM on its way.
Cheers
Paul
Re: Breaking Z3
They did and I think I still have them - I'll check at the weekend.Gooseacre wrote:Did the bonnet hinges survive unmangled?
Cheers
Paul
- EnthuZiaZT
- Joined: Sat 12 Sep, 2009 14:27
- Posts: 443
- Location: Heacham, Norfolk
- Contact:
Re: Breaking Z3
Thanks Paul, The water bottle arrived today, unfortunately, it's the wrong one. Our bottle is located on the bulkhead on the rear of the engine bay. However we will probably put it on Ebay.
Mike & Sandy - Mora Metallic Individual 2.0L
IMG_1038.jpg~original
IMG_1038.jpg~original
Re: Breaking Z3
Hi, I'm after a hard top for my Z3M - can you let me know if yours is still available?
Re: Breaking Z3
I'm after the face level centre air vent (above the radio) if they're black (part no. 64228397713)