Induction kit question

simon-g · Post by **simon-g** » Sat 24 Apr, 2010 08:27

I have a Vader induction kit that I want to use again from my old car. I have trial fitted it without removing the air box and it will just fit as long as piping connecting it to the MAF sensor is kept short.

Does anyone know what size of piping i will need to connect it to my car, Z3 2.8, the new inuduction kits inlet pipe is 7cm diameter. The one on the car looks much bigger, without removing the airbox I cant measure it.

Tori · Post by **Tori** » Sat 24 Apr, 2010 09:08

I used a 76mm- 67mm silicone section it was tight to get on but it does the job, the rest of the pipework and couplings are 70mm.

http://www.zroadster.net/forum/viewtopic.php?t=24883

simon-g · Post by **simon-g** » Sat 24 Apr, 2010 09:18

Thanks Tori