UK forum for general and technical discussion about the Z3 roadster
6 posts • Page 1 of 1
Not sure if I agree that the bearing make is not important. Some of the unbranded bearings sold on ebay are rubbish and can fail quite quickly. A very good, premium make is SKF who make many OE bearings for manufacturers and another is INA. Eurocarparts also offer a brand called Orbis which is part of Lucas.
Allow plenty of time, I haven't done one on a Z3 but have done several types of 3 series cars over the years, none of which was easy. All needed the rear suspension arm removing to allow the bearing to be pressed out. Do you have access to a press? Even if you are mechanically minded it could still take 3-4 hrs.
"Knowledge and experience are not always the same"
Who is online
Users browsing this forum: Bing [Bot], BladeRunner919 and 6 guests