Hi All,
I'm looking to upgrade my drivers seat to a fixed back seat, the standard seat provides hardly any support around corners, even with seat spacer mod installed.
I'm struggling to find a UK supplier for the sliders and mounting brackets, ideally i would like to use sliders but fixed is an option.
What setup does everyone run?
Thanks
Bucket seat sliders/side mounts
Re: Bucket seat sliders/side mounts
I Have these in my car, Sparco R100 seats, Sparco Manual Adjusters and Planted seat bases. The bases are about as expensive as the seats but as it is a safety item I did not mind.
Re: Bucket seat sliders/side mounts
That's interesting. I was wondering how after-market seats got fitted.
I guess there's about £400 a side of seat and mounting there? Or more if the seats are leather rather than vinyl?
What's the harness for if they are manual?
I guess there's about £400 a side of seat and mounting there? Or more if the seats are leather rather than vinyl?
What's the harness for if they are manual?
2001 Z3 2.2 Topaz Blue (Trudy) - Keeper rebuilt from a write-off
2002 Z3 2.2 Titan Silver (Cookies) - Keeper rebuilt having been bought with a seized engine
2002 Z3 3.0 Sapphire Black (Peanut) - Keeper awaiting rebuilding having been bought as an abandoned project
Plus Willy, Kodak & Maycee - All 2.2 Sport projects. Yes, 6 is a lot of Z3s
Always happy to try and help with spares
Re: Bucket seat sliders/side mounts
Seat belt pre tensioner.mrscalex wrote:What's the harness for if they are manual?
Re: Bucket seat sliders/side mounts
Okay, so that assembly get's transferred from the original seat then? Makes sense.Brian H wrote:Seat belt pre tensioner.mrscalex wrote:What's the harness for if they are manual?
But isn't the yellow part of the connector usually the one on the car and it's a black connector on the seat harness?
2001 Z3 2.2 Topaz Blue (Trudy) - Keeper rebuilt from a write-off
2002 Z3 2.2 Titan Silver (Cookies) - Keeper rebuilt having been bought with a seized engine
2002 Z3 3.0 Sapphire Black (Peanut) - Keeper awaiting rebuilding having been bought as an abandoned project
Plus Willy, Kodak & Maycee - All 2.2 Sport projects. Yes, 6 is a lot of Z3s
Always happy to try and help with spares
Re: Bucket seat sliders/side mounts
No, this is the standard way, I just swapped it over. On the passenger seat I had to use an airbag seat occupancy bypass box of tricks to simulate somebody sat in the seat, the downside of this is that if the airbags do fire both will go off even if nobody is in the passenger seat. Once this was fitted I used INPA to check the status of the seat and all is good.mrscalex wrote:But isn't the yellow part of the connector usually the one on the car and it's a black connector on the seat harness?