wonderloaf wrote:In my zed I've got a Kenwood KDC-w7044u head unit with just about every sound customization going, with Fusion components at the front and Kenwoods in the rear. Initially I bypassed the footwell amp and played around with the sound settings, but just couldn't get it right, the sound didn't seem to have any 'oomph'.
I then reconnected the footwell amp and now have the oomph that I'm after, only problem is if I turn it up too loud I get a bit of distortion.
I notice I have some RCA connectors (lower level?) for connecting to Front outputs a separate amp, would I better off using these to connect to the foot-well amp, but keep the existing speaker connections for the rears?
As you can tell I'm a bit of a at ICE!
wonderloaf wrote:Power of my HU is 50W per channel max, 30W DIN 4534 (RMS?).
Just been out and removed and bypassed the amp again to give it another go, maybe I had the HU set up wrongly previously as it was new and I was unfamiliar with it.
wonderloaf wrote:Sorry should have explained myself better, have also replaced the tweeters in the doors with those that came with the component speaker set. Only thing is that I didn't use the crossovers that came with the set as I couldn't see an (easy) way of wiring through the door hinge. Will this make a big difference?
I've got Fusion components and I read somewhere that the tweeters have built in crossovers, don't know if that's true or even possible.
BTW thanks for answering these posts, these are things that have been on my mind but never got around to asking!
Users browsing this forum: No registered users and 1 guest