UK forum for general and technical discussion about the Z3 roadster
6 posts • Page 1 of 1
the screen wash stopped working the other day so I had a look under the bonnet pump was making it nomal noise so I thought I would see if the pipe was blocked, from the washer tank (near side by the wind screen)the pipe goes across the back to the off side through a pannel by the fuse box down under the fuse box up again to the front of the fuse box through the pannel again arround the offside of the fuse box then up to the bonnet to the jets, I pulled off each junction to see if the pipe was blocked from the jets to the first junction by the fuse box -just a dribble ,new pump on order.any one no why the pipe goes all the way arround the car rather than just straight up from the tank to the bonnet -jets
I had the same problem with my washers not working, if you remove both pumps (if headlamp washers fitted) then take the pump grommets out, these incorporate a filter which blocks up & is often overlooked.
Hope this helps.
Hope this helps.
Remember that on some Z3s the washer bottle is front left of the engine bay not rear right. It's possible BMW wanted to keep a single entrance point up onto the bonnet.
1999 Z3 1.9 Boston Green (Dimitri) - My brother's car owned from new and restored by me
2001 Z3 2.2 Topaz Blue (Trudy) - My car rebuilt from a write-off
2002 Z3 2.2 Titan Silver (Okus) - Project car waiting for a new engine
2001 Z3 2.2 Topaz Blue (Debra) - Donor car/breaker
1998 Z3 1.9 Boston Green (Allsworth) - Donor car/breaker now gone to Z3 heaven
Always happy to try and help with spares
prevents freezing in cold temperatures. The engine warms the pipes
''need I remind you 007, you have a licence to kill...not to break the traffic laws''
Who is online
Users browsing this forum: Google [Bot] and 10 guests