Have you ever thought "Those discs look rusty, I wish I had something to clean them up with".
Well, here it is the Pingu Disc Skimming Attachment for a pedestal drill / milling machine...
How to make and use it...
and the maths behind finding the Pitch Centre Diameter (PCD)...
Making a Disc Skimmer
-
- Joined: Tue 26 Jan, 2010 19:44
- Posts: 1026
- Location: mars
Re: Making a Disc Skimmer
Inspector gadget srikes again, is there no end to your inventions,
Must say tho im a bit stumped as to the operating process,or am I being thick ,
M
Sent from my GT-N8010 using Tapatalk
Must say tho im a bit stumped as to the operating process,or am I being thick ,
M
Sent from my GT-N8010 using Tapatalk
Re: Making a Disc Skimmer
I have had this in mind for the last couple of years but never got around to it, great minds think alike eh!
Aceman
Arctic Silver '98 Z3M
Previously;
Bright RED '99 Z3 2.8
Rocking seats ? You need seat bushes click HERE
Arctic Silver '98 Z3M
Previously;
Bright RED '99 Z3 2.8
Rocking seats ? You need seat bushes click HERE
-
- Joined: Tue 26 Jan, 2010 19:44
- Posts: 1026
- Location: mars
Re: Making a Disc Skimmer
Or u could do it on a small lathe.
Just sent a shiver down me spine.spent nigh on 20yrs bent over a lathe.
M
Just sent a shiver down me spine.spent nigh on 20yrs bent over a lathe.
M
Re: Making a Disc Skimmer
Small lathe is too small. 180mm od is about the biggest job before it fouls the bed.maurice the martian wrote:Or u could do it on a small lathe.
Just sent a shiver down me spine.spent nigh on 20yrs bent over a lathe.
M
Pingu